Controlador Wifi Hp 425

• HP 425 802.11n Access Point Quickstart This Quickstart shows you how to install and get started using the HP 425 Dual Radio 802.11n Access Point, hereafter referred to as the AP. Important: Minimum controller software versions are required to operate this AP. For more information, see the HP MSM3xx / MSM4xx and HP 425 Access Points Release Notes v6.2.x. • HP 425 Wireless Dual Radio 802.11n Access Point Quickstart Important information to read before installing Ports Plenum installation: The AP can be installed in a plenum. The AP is suitable for use in environmental air space in accordance with Section 300-22(C) of the •. • 2: Screw hole 3: Clip 4: T-rail hook cut-out HP recommends that you connect power and verify the Ethernet cable and LEDs before you install the AP in a hard-to-reach location.

HP 425 Wireless Dual Radio 802.11n Access Point Quickstart 3 Selecting the installation site Selecting the installation site Consider the following. The HP wireless controllers support a fast-roaming capability-an important feature. The HP 425 access point works in managed mode with an HP wireless LAN controller. Driver wireless HP 425. ME COSSTO UN UEEVOOOOOOO encontarrlos xk a pesar de buscarlos x modelo no funcionaban. Dp de muchiiiiisimas vueltas buske x numero de id del.

Record the MAC address and AP serial number for future reference. • HP 425 Wireless Dual Radio 802.11n Access Point Quickstart Installation Loosen, but do not remove all four M3 screws (7) on the clip holders (3). Hook the mounting bracket clip (3) onto the T-rail holder mounting hook (2).

1: T-rail clip. • AP and the controller are on the same subnet and have IP connectivity. For more information about using the AP with HP WLAN Module, HP 830, or WX5002/WX5004 Controllers, see the HP 830 Switch and HP 20G Module Access Controller Module Basic Configuration Guide, or the H3C WX Series Access Controller Module Configuration Guide. • AP status LEDs your radio settings, it may be mandatory to reduce the radio transmission power level to maintain regulatory compliance.

For specific power limits for your country, see the HP 425 AP Antenna Power-Level Setting Guide available LED color State Description from www.hp.com/support/manuals.

Hello, Yesterday an access point was delivered by our service provider. They claim it can be configured as a standalone access point. However when I look at the HP site I can only find manuals which reference using the radio in combination with a HP Wireless controller/Management device. Does anyone have any experience with these Access Points? I've contacted HP Support, but they refer me to our HP partner. They do not want to provide me with a manual or directions.

They'd rather send a engineer on site to configure it. Pc Games Below 300mb. (which I doubt will be any help, but will gain them some income:) ) screenshot of the management interface.